![]() Make sure that your sound source is properly assigned to the channel you are sending on. Since the ST900 has only one zone, you can only program one of the l6 channels at a time. Each channel would normally be assigned to a different sound or effect. Set your sound sources to the desired MIDI channelsbythe ST-900. The Studio 900 will accept an adapter that has a rating of 9V DC with a positive polarity tip and has a minimum current of 200 ma.ΔΆ) Connect MIDI cable from the ST-900 s MIDI outputs, (each output can handle up to four synthesizers, modules, or effect devices) to the MIDI input on your sound sources. ![]() Make sure that the AC adapter corresponds to the correct voltage output. 1) Connect the AC adapter cable to the power input jack, in the back of the controller, located next to the power switch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |